Integra cluster swap into Civic

[Gubo22]

The Integra cluster bolts into civics but the wires need to be re-arranged to Integra specifications and it needs to be re-fitted.

Tools Needed

1) #2 Phillips Screw Driver
2) Connectors for the 92-95 install
3) Needle Nose Pliers
4) Lots of Patients

Remove the civic cluster
Pull all the pins from the 2 civic plugs
Re-arrange them to the following specs
Install Integra cluster using swift ties or a custom bracket
ENJOY!

Now Here Comes The Tricky Part. PAY ATTENTION!!!!

for a 92-95 civic
The plugs from the EG do not fit the back of the Integra Cluster. You will either need integra plugs or EK plugs to do it.

http://www.4bangercity.com/images/92civiccx/civic27.jpg
Integra Blue Left Side Plug (13 pins)
1. BLU - Tach signal
2. GRN/ORG - Check engine indicator
3. YEL/RED - Oil pressure switch
4. -
5. WHT/BLU - Charge indicator
6. -
7. YEL/GRN - Coolant temp
8. BLK - Ground
9. RED/BLU - Cruise control (if you have cruise)
10. YEL - Hot
11. -
12. PINK - Maintenance (not used)
13. -
Integra Right Side Blue Plug (16 pins)

1. GRN/RED - E-Brake signal
2. RED/GRN - High beam
3. GRN/YEL - Right turn
4. GRN/BLU - Left turn
5. -
6. BLK/YEL - Power
7. RED/BLK - Power
8. RED - Power
9. BLU/RED - ABS (not used)
10. GRN - Trunk switch
11. ORG - Vehicle speed sensor
12. -
13. BLU/WHT - Low fuel (not used)
14. YEL/WHT - Fuel gauge
15. LGT. GRN/RED - Door switch (not used)
16. RED/BLU - Seat belt
__________________________________________________


for a 96-00 civic (ITR shown)
http://patriot.net/~merritt/interior/P1010536.jpg

Plug B
http://www.fifthgearonline.com/insta...s/cluster2.jpg
B1 - Yellow / Black - Seatbelt Light
B2 - Empty
B3 - Red / Blue - Fuel Gauge
B4 - Green / Yellow - 2 Silver Stripes - Low Fuel Light
B5 - Empty
B6 - Blue / White - Speedometer
B7 - Blue / Black - Trunk Light
B8 - Empty
B9 - Red - Brightness
B10 - Red / Black - Gauge Lights
B11 - Black / White - VSS
B12 - Empty
B13 - Green / Red - 1 Silver Stripe / Left Turn Signal
B14 - Green / Yellow - 1 Silver Stripe / Right Turn Signal
B15 - Red / Green - Not Available
B16 - Green / Red - 2 Silver Stripes - Emergency Brake

Plug C
http://www.fifthgearonline.com/insta...s/cluster1.jpg
C1 - Empty
C2 - Pink - Washer Fluid Level - Canada Only
C3 - Empty
C4 - Yellow - Dimmer
C5 - Empty
C6 - Empty
C7 - Black - Ground
C8 - Yellow / Green - Temperature
C9 - White / Blue - Battery
C10 - Empty
C11 - Yellow / Red - Oil Pressure
C12 - Green / Orange - Check Engine Light
C13 - Blue - Tachometer

Credit:
Merritt
5th Gear
Honda Tech

I have done about 4 of these installs
2 EK
1 1.6el
1 EG <Thanks for being sooo patient! You know who u r.

The EG was the hardest as the clips needs to be replaced with EK or DC2 ones and the trim on the cluster has to be shaved flat.

[Psykopathik]

pimp write up!

Sticky!

[Gubo22]

Thanks doode!

Here is one of the EGs I did.
For the EG the fitment is not as good.
The cluster was only zap strapped in but we are going to make brackets and fill the gap later on.
http://www.imagestation.com/picture/...1/face9a4a.jpg
http://www.imagestation.com/picture/...b/face9a52.jpg