such a sexy car. i have a serious itch to get one of these as a little weekend cruiser.

[QUOTE=BABU;8299247]Test fit new wing stands

I hope you have a pilots license? Cause that car is ready to fly.

ken!! wth you painted your wheels or did you get new ones?

/\/\ plasti dip mike!

New front brake pads and rotors. Only took 7 hours over last night and this morning thanks to (a) seized caliper piston (b) driving to Lordco Kingsway from Richmond as they were the only place open late, and (c) clueless Lordco clerk who gave me the wrong caliper.

Destanced the ride, so itll be easier to sell rims, raise the coils abit but still staying low on the18" stockies
Looks hella sunk :okay:
Will post pics once alignment is done tomorrow at drivehard. Camber on stocks :facepalm:
Will post further pics once I pick up new rims :fuckyea:
Some of u already seen my teaser of the next rims. gonna look sweet all i can say.

^^^ have 2, 25mm and 2, 20mm 5x114mm spacers

The wheels you showed me before? Thought you were staying stock?

yea next rims are mine once I come up with the coin for it...hopefully with the currents dismounted it'll sell easier.
if it gets to end of September then ill stick with stocks and set up for spring again....if I don't have a van by then :lawl:

gave my civic an sti.. :pokerface:




lip
http://i65.photobucket.com/albums/h2...ps6da34607.jpg

Removed the seats f/r, armrest, console and door panels to give it a thorough cleaning.

Tomorrow, cleaning the door jambs, trunk jamb and engine bay.

Do it, they're a lot of fun and very comfortable. And H22 + CAI + VTEC = sex.

Let mine get rained on while we installed a shift kit and trans cooler in a 03' nissan altima to correct the bad shifting and repaired the rusty quarters of a miata.

got my j pipe put in with the help from paradise240

Went Home Depot on it.

http://i282.photobucket.com/albums/k...ps55117b19.jpg

http://i282.photobucket.com/albums/k...psf7531bdf.jpg

Just using these until I can find money and time to retrofit some FD or Evo splitters on.

Stock taillights of Elantra GT

http://i.imgur.com/3xfn8IP.jpg

Swapped in Korean OEM lights for KDM i30 (i30=elantra GT)

http://i.imgur.com/hlXcXVb.jpg

will get better photo later at night.. if i am feeling up for it...
basically we have the crappy halogen NA tails, while europe/korea has LED tails...

Need to see shot of OEM lights in the day and night, and KDM lights in the day and night, not just one of each.

Wow big difference. Looks much better now. Way more modern.

Did this yesterday, self explanatory
http://i39.tinypic.com/2jed1zr.jpg

Shot with daylight this morning
http://i44.tinypic.com/rbmz35.jpg

Within the past few days: Better wheel fitment w/ thinner/shorter tires, fixed most of the diffuser fitment problems, and finally quad tips!

http://s8.postimg.org/64hgokzwl/qqq.jpg

:notbad:

Good job. I wish my car looked like that. What's next?

Thanks!

To do list:

CF Arkym front lip
CF side skirt splitters
Fog light removal for custom 335is ducts

If I tune the car:

Open Flash Tablet
FMIC
AR Catless DP's
Cyba scoops
BMS DCI

Maybes:

CF hood (vorsteiner, duke dynamics or m3)
LCI Tail lights
Sway bars

:drool

Being a student sucks sometimes. You should start a build thread on here.

New air intake boot, coils and spark plug wires, which fixed the idle issue and greatly improved drivability. Cheap maintenance fixes :fullofwin:

Got through tank #2 of gas, time to remove the silencer and hit full boost :fullofwin:

Pulled front fenders slightly. Getting ready for even more low..