Did you have to reprogram the remote on the switch blade fob?

It looks like one of those ones where you have to remove the inside on the old remote and install it into the new casing so don't need to program.

Got this..... Now to get the rest of the hardware

http://i88.photobucket.com/albums/k1...ps3619b8dd.jpg
Posted via RS Mobile

I hate those f'in honda rotor screws.........I would have left them out

Can you imagine working with me? :troll:

stripped out the center console of the Prelude, and trimmed down the extra plastic that sits under the front of the boot. looks much better now

Got off work early so I ended up putting in the turbo inlet hose the hard way... Won't be able to put it back together cause Subaru won't have my gaskets till next week.

http://i7.photobucket.com/albums/y25...2F3DCB865B.jpg
http://i7.photobucket.com/albums/y25...2F4E587183.jpg
Posted via RS Mobile

They weren't bad to get off at all really

:fulloffuck:

Hey! I did get the rear ones off by myself, just used the right screw driver and they came right off!

Exactly

Excuse the instagram... but purchased smoked corners.

http://distilleryimage9.s3.amazonaws...0a9e28e1_7.jpg

Delete 30% metal bolts under Engine bay, swap in the alumium washer kits. It saves 2 KG weights. 30% finished, 70% to go. So tired.

Raged.

http://distilleryimage7.s3.amazonaws...0a1f97a4_7.jpg


edit: jk, scrapped my old bumper

gave her a good cleaning

My headlights look like this...

http://i1061.photobucket.com/albums/...ps1fd1e0f2.jpg

So I bought this...

http://i1061.photobucket.com/albums/...ps7f1c8d79.jpg

I'll do it next time I get a few hours to spare.. been working on vehicle too much recently, need to study for exams.

Went to wash my car, halfway through waxing outside it started raining. Had to haul ass back home into my parking garage and re-wax half my car :okay:

The Weather Channel is seriously very, very unreliable most of the time.

Made a new rad shroud for the volvo fan. Cost less than $20 for everything. Just need to weld the tabs on.

Volvo electric fans are really nice. I got 2 setups for $60. They are a 2 speed fan and have a nice self contained relay unit that ramps up the fan so there isn't a huge amperage draw like a taurus setup.

I'm doing all this to install a 2000+ vitara rad so my hoses are routed better for the diesel swap.

Got my block back yesterday from the machine shop, started to assemble the engine again:

https://fbcdn-sphotos-h-a.akamaihd.n...75244051_n.jpg

https://fbcdn-sphotos-g-a.akamaihd.n...39088450_n.jpg

washed my cars, guess its not much but i havent washed them since ive own them pretty much. im always too afraid of washing the paint right off the rust lol, luckily silver doesnt really get dirty

http://i349.photobucket.com/albums/q...psfe5b1175.jpg
http://i349.photobucket.com/albums/q...ps571c13fb.jpg

http://i349.photobucket.com/albums/q...ps78dd6fd1.jpg
http://i349.photobucket.com/albums/q...ps7bee14fd.jpg
http://i349.photobucket.com/albums/q...psb983c9b8.jpg

it was a lot harder than it seemed (2 of the cars have no motors so i had to push it out and back in x_x)

did an oil change on my car and installed Qwik Valve for less messy oil changes
http://i.imgur.com/3VqohcB.jpg

http://i.imgur.com/IBBftnD.jpg

now i just need to wash the car

Today I paid someone to change my oil.

:troll:

Wash, Clay bar, And Waxed.

http://i738.photobucket.com/albums/x...ps64128f15.jpg

decided to black out my rear reflectors, did a half ass job. fine from far but far from fine lol.

http://i1287.photobucket.com/albums/...ps745cb69c.jpg

Also washed the rear part of my car leaving it shiny and the rest full of dirt haha

On the daily I...
- tightened ebrake cable
- tightened the nut that comes with the Blox 490g shift knob so the knob part of it centers properly
- ripped apart center console to install new aux. input cable that goes in the back of my deck
- took the opportunity to reroute the power cable through the console to the cigarette lighter for the dash cam

Been itching to insure the Miata but told myself I wouldn't until a few days before the Spring meet... trying hard to abide to this!