My item list for b16a2 belt / seals / gaskets job - am I missing anything?

[Delicieuxz]

Hi. I'm in the process of ordering all the parts for when I open up my engine to do the timing belt. It will be the first time that I've done it, myself.


Here's what I've ordered so far:

vtec solenoid gasket
cam plug
camshaft oil seals
distributor o rings
dowel pin & o ring

Added:

crank bold
main seal


Here's what else I'm going to order:

timing belt
water pump
tensioner & spring
head cover gasket set


I replaced the alternator, AC, and power steering belts a few years ago and I've barely driven the car since then, so I'm not expecting to have to replace them during this job. I'm thinking of using a gatorback timing belt, because that's what was put in it last time, and it's been good for me, no noise.

The car is a 99 EM1, and hasn't had any engine parts servicing since 2007, other than the replacing of the alternator, PS, AC belts and the motor mounts.

Is there anything missing from my list that I should be replacing while going to the trouble of taking everything apart? Thanks.

[fliptuner]

Crank pulley bolt and maybe a main seal.

[Delicieuxz]

Originally Posted by fliptuner

Crank pulley bolt and maybe a main seal.

Ordered those now, too.

[fliptuner]

Make sure you follow the correct procedure for installing that bolt. I believe it's xx torque, followed by xx degrees.

Yes, I've used old bolts without issue, just gunning it on but I've also seen broken and over-torqued bolts. Best to just do it right.