Quote:
Originally Posted by Phil@rise
You went quite a bit to far with your hacksaw and ruined your factory knuckle. It may crack now as a result.
Hotkarl chill out.
|
Phil yea, I took my time with the upper cut stopping and checking every few minutes, took about 20+ minutes...
but I was really pissed off when i was doing the second cut, just lost my mind a little bit kept sawing like a madman, didn't stop to check and cut into the arm.
I don't know, I don't think it's that big of a cut to cause the arm ring there crack break and fall apart but I will be checking for cracks occasionally, if even the smallest crack appears I'll just replace the whole arm, it's not that expensive for the arm, but labor is gonna be a bitch, I don't have any power tools in my garage.
this is the Kinetix spindle that went in with the new kit
