how much you selling for??
ps here is what was done to my car last night!
chopped up my lower rad support, made brackets for the half rad and welded them to the traction bar! if some of you are not aware ef/ed have a very short rad and little clearance under the hood so swapping in a half rad of almost any kind doesnt fit too well..
also discovered my downpipe is nowhere close to fitting so that will be cut up and made to fit this week
and again.. one step forward and two steps back, while the new mount that i made for my car was off i was rocking the engine and noticed a "clanking" sound... sure enough my rear engine mount is pretty much non existent! the main bolts holding it down were stripped and the mount itseft had a huge crack around the bolts..