REVscene Automotive Forum - View Single Post

hud 91gt · 10-12-2016, 05:26 PM

I have a bunch of time off work so my goal was to install my megasquirt, and sell my condo.

Condo is gone, but Megasquirt to go.

Today I made a bracket to fit up under the dash. Went back to the days of shop class and bent up some ABS.

Bare $3 scrap sheet from Industrial Paints and Plastics

As the British dude dubbed, some CAD (Cardboard aided design)

Bent up with a $12 heat gun and some 2x4's and test fitting in place with the MS.

Almost finished, wiring to go

Then when I was done that, I started on a bracket for my LS2 coils. I'll mount all 6 of them on this piece of aluminum angle I cut up with my angle grinder. Certainly not perfection, but will look good from far and most importantly... it'll work.

That's it for today... and tomorrow is furniture selling time. Till the weekend!

10-12-2016, 05:26 PM	#7047
hud 91gt RS.net, helping ugly ppl have sex since 2001 Join Date: Feb 2002 Location: Vancouver Posts: 8,419 Thanked 4,040 Times in 1,562 Posts Failed 35 Times in 27 Posts	I have a bunch of time off work so my goal was to install my megasquirt, and sell my condo. Condo is gone, but Megasquirt to go. Today I made a bracket to fit up under the dash. Went back to the days of shop class and bent up some ABS. Bare $3 scrap sheet from Industrial Paints and Plastics As the British dude dubbed, some CAD (Cardboard aided design) Bent up with a $12 heat gun and some 2x4's and test fitting in place with the MS. Almost finished, wiring to go Then when I was done that, I started on a bracket for my LS2 coils. I'll mount all 6 of them on this piece of aluminum angle I cut up with my angle grinder. Certainly not perfection, but will look good from far and most importantly... it'll work. That's it for today... and tomorrow is furniture selling time. Till the weekend! __________________ Crush - 1971 Datsun 240z - Build Thread The Daily - Rav4 V6 - “Goldilocks”