[Fafine]

Originally Posted by MG1

I went to the Milwaukee Service Centre yesterday, looking for their new Packout parts. While there, I asked about the bit holders and how much they were. I couldn't believe it. 81 cents????? That was for the two screws, lol. The actual part was less....... 72 cents. They have different ones for different drills and screw guns. You need to give them your model number. As long as the tool you have has the threaded holes, you're good to go.

These people at this location do not have a phone (public), so you can't contact them directly, but they do have a national support line where they can give you prices and availability.


I guess I bought more than just two or three, because I have bit holders on both sides of my drills. You can unscrew the belt clip that came with your drill and put a bit holder in its place, lol.


https://www.milwaukeetool.ca/support...service-centre

toll free number at bottom...............

Thanks again! I went yesterday morning and they just gave me two for free!