[Razor Ramon HG]

Originally Posted by radeonboy

I printed a small one in the link below - it's low-profile and I don't use my printer too much so it's large enough for me. It has a hole for you to insert a 0.5"d x 0.1"h magnet.

https://www.printables.com/model/333...tic-poop-chute

Where did you buy your magnet? I'm having trouble finding both a 0.5" diameter magnet that's also 0.1" in height.

Is the magnet strong enough to hold the chute up or should it be supported by something below?

I currently have my printer on an Ikea Lack table, thinking of putting the printer on a concrete slab to make the table vibrate less and add more stabilization.