Quote:
Originally Posted by Razor Ramon HG
Pretty good for a first print.
I used the same settings I used for PLA and the default PETG filament temperature (255/80). Had some minor stringing and nubs that I needed to clean up at the end, but screws came out perfect.
Screws go in perfectly, but was a little tight so I added a bit of lube. It's perfect now.
I think next time I print PETG, I'll lower the temperature to 240 for the hotend and then see if I need to adjust the speed.
Going to try another print. Send me a PM @OriginalJC for when you want to pick this up. |
Nice that’s awesome. And quick! I’ll send you a PM, cheers