Quote:
Originally Posted by SSM_DC5
Perfect! Almost every aspect is what I was planning! For the dishwasher on the end that meets the waterfall counter, did you put a cover panel there? Ikea's program auto-populates to put one there. But then it would need another cover panel for the 15" cabinet as a filler right?
I need to figure out a solution for gfci outlet because of code and I don't really want to put it on the waterfall sides. Toekick would be great if I meets code, which I have no idea if it does. I think I'll likely have to use 2-3 inches of filler and put the outlet between waterfall and dishwasher.
Does your flooring go under island?
Did you screw down your 2x6 to the floor? Then cabinet to the 2x6?
Did you happen to compare cost of 45 deg mitered waterfall vs 90 degree joint?
|
The dishwasher is actually not on the side, it is the 2nd cabinet from the left, inbetween the side cabinet and sink cabinet, so didn't have any cover panel there.
I had the wood floor installed first and it goes all the way to the wall so all the cabinet can just sit on top.
I measured out exactly where I wanted the island to sit and put a few L-bracket on the 2x6 frame attached to the floor, so it wouldn't move around while I am working on it.
I didn't know they offer 90degree joint for the water fall edge... It is the same amount of materials used....I don't think there would be any price difference between doing a 45' cut vs 90' cut for the countertop fabricator?
The only reason I see doing a 90' cut is if you need the waterfall edge as a leg support the top? Otherwise the mitre edge def looks nicer